Sapphire Plug-ins for Autodesk: ShowBadColors

ColorOps: ShowBadColors

In the S_ColorOps Plugin.

Identifies all pixels that fall outside a given color range, and flags them with the same color so they can be seen easily.

Inputs:

Source: The clip to be processed.

Parameters:

Load Preset: Push-button .
Brings up the Preset Browser to browse all available presets for this effect.

Save Preset: Push-button .
Brings up the Preset Save dialog to save a preset for this effect.

Min: Default: 0, Range: any.
Minimum color value. Pixels where any color channel is less than this value will be marked with Low Color.

Max: Default: 1, Range: any.
Maximum color value. Pixels where any color channel is greater than this value will be marked with High Color.

Min Luma: Default: 0, Range: any.
Minimum luminance value. Pixels where the luminance is less than this value will be marked with Low Color.

Max Luma: Default: 1, Range: any.
Maximum luminance value. Pixels where the luminance is greater than this value will be marked with High Color.

High Color: Default rgb: [1 0 0].
Color to mark high pixels with. Any pixel that is above one of the Max parameters will be set to this color.

Low Color: Default rgb: [0 0 1].
Color to mark low pixels with. Any pixel that is below one of the Min parameters will be set to this color.

Min Rgb: Default rgb: [0 0 0].
Minimum values per color channel. Pixels where any color channel is below the corresponding channel of this parameter will be marked with Low Color.

Max Rgb: Default rgb: [1 1 1].
Maximum values per color channel. Pixels where any color channel is above the corresponding channel of this parameter will be marked with High Color.

Min Chroma: Default: 0, Range: any.
Minimum chrominance value. Pixels where the chroma is less than this value will be marked with Low Color.

Max Chroma: Default: 1, Range: any.
Maximum chrominance value. Pixels where the chroma is greater than this value will be marked with High Color.

Output Matte: Check-box,  Default: off.
If enabled, output a matte which is set to white for bad pixels and black otherwise.

Invert Matte: Check-box,  Default: off.
If enabled, the matte is inverted to show black for bad pixels and white otherwise. Has no effect unless Output Matte is also enabled.
See general info for: Res , On Fields , Redraw , Undo , Load Defaults , Crop , Add Noise , and Use Gamma .


See Also:

HueSatBright
Monochrome
ClampChroma
PseudoColor
DuoTone
TriTone
QuadTone
Tint
Threshold
Hotspots
Gamma
Solarize
ChannelSwitcher
Invert
Sapphire Plug-ins Introduction

PRODUCT UPDATES & SPECIAL OFFERS

Join our email newsletter and keep up to date