Sapphire Plug-ins for Autodesk: SwishPan

Wipes: SwishPan

In the S_Wipes Plugin.

Transitions between two input clips by sliding one clip off the frame and the other clip on, and adding motion blur to give the appearance of a quick pan. This works best when the duration of the transition is short.

Inputs:

From: Starts the transition with this clip.

To: Ends the transition with this clip.

Parameters:

Load Preset: Push-button .
Brings up the Preset Browser to browse all available presets for this effect.

Save Preset: Push-button .
Brings up the Preset Save dialog to save a preset for this effect.

Amount: AutoTransition,  Default: 0, Range: -0.5 to 1.5, Shared .
The transition ratio between the From and To inputs. A value of 0 gives only the From input and a value of 1 gives only the To input. By default this parameter will automatically animate from 0 to 1 to perform a complete wipe.

Blur Amount: Default: 2, Range: 0 or greater.
Amount of motion blur to use. If the direction is left or right, the blur is horizontal. If the direction is up or down, the blur is vertical.

Overlap: Default: 0, Range: any.
Amount to overlap the two clips. Where the clips overlap, they will be screened together. This is useful for eliminating bad edges.

Direction: Popup menu,  Default: Left .
Direction that the clips move during the transition.
Left: Moves right-to-left
Right: Moves left-to-right
Up: Moves upward.
Down: Moves downward.

Slow In: Default: 0.5, Range: 0 or greater.
If positive, causes the transition to start more gradually.

Slow Out: Default: 0.5, Range: 0 or greater.
If positive, causes the transition to end more gradually.
See general info for: Res , On Fields , Redraw , Undo , Load Defaults , Crop , Add Noise , and Use Gamma .


See Also:

Swish3D
Blur
Sapphire Plug-ins Introduction

PRODUCT UPDATES & SPECIAL OFFERS

Join our email newsletter and keep up to date