Sapphire Plug-ins for Autodesk: FlickerRemoveColor

FlickerRemoveColor

In the S_FlickerRemove Plugin.

Removes temporal color changes from the Source clip. Similar to FlickerRemove but the process is applied to each color channel. To use this effect, first position the rectangle over an area where the average color should remain constant. A middle or light gray area is best for this. Then select a Source frame that has the desired color within the rectangle, and hit the Set Hold Color button. When other frames are processed, their colors will be scaled so the average color within the rectangle is equal to the Hold Color.

Inputs:

Source: The clip to remove color changes from.

Parameters:

Load Preset: Push-button .
Brings up the Preset Browser to browse all available presets for this effect.

Save Preset: Push-button .
Brings up the Preset Save dialog to save a preset for this effect.

Rect Center: X & Y,  Integer,   Default: [0 0], Range: any, Shared .
The center of the rectangle which is used to measure the flicker, in screen coordinates. This parameter can be adjusted using the Rect Widget.

Rect Size: X & Y,  Integer,   Default: [1.67 1.23], Range: any, Shared .
The size in pixels of the rectangle used to measure the flicker. This parameter can be adjusted using the Rect Widget.

Set Hold Color: Push-button .
Pressing this button sets the Hold Color parameter to the average Source color in the rectangle at the current frame. It causes the output to equal the Source at this frame. (This will not work properly when in 'Redraw:Never' mode.)

Hold Color: Default rgb: [0.5 0.5 0.5].
The requested average output color for the area within the rectangle.

Measured Flicker R: Default: 0, Range: 0 or greater.
When processing, this parameter is automatically adjusted to record the amount of flicker in the red color channel at each frame. You can copy the keyframes to a parameter in other effect in order to match the flicker in a different clip, or adjust the brightness on certain frames. Changing this parameter manually has no effect.

Measured Flicker G: Default: 0, Range: 0 or greater.
When processing, this parameter is automatically adjusted to record the amount of flicker in the green color channel at each frame. You can copy the keyframes to a parameter in other effect in order to match the flicker in a different clip, or adjust the brightness on certain frames. Changing this parameter manually has no effect.

Measured Flicker B: Default: 0, Range: 0 or greater.
When processing, this parameter is automatically adjusted to record the amount of flicker in the blue color channel at each frame. You can copy the keyframes to a parameter in other effect in order to match the flicker in a different clip, or adjust the brightness on certain frames. Changing this parameter manually has no effect.

Params2:

Center Shift: X & Y,  Integer,   Default: [0 0], Range: any, Shared .
These values are added to the Rect Center, and are meant to help when using data from the Tracker.

Negate Shift: Check-box,  Default: off, Shared .
If enabled, the Center Shift is subtracted from the Center instead of added.
See general info for: Res , On Fields , Redraw , Undo , Load Defaults , Crop , Add Noise , and Use Gamma .


See Also:

FlickerRemove
FlickerRemoveMatte
FlickerRmMatteColor
FlickerMatch
FlickerMatchColor
FlickerMatchMatte
FlickerMchMatteColor
Flicker
Sapphire Plug-ins Introduction

PRODUCT UPDATES & SPECIAL OFFERS

Join our email newsletter and keep up to date