Sapphire Plug-ins for AVX2: SwishPan


Transitions between two input clips by sliding one clip off the frame and the other clip on, and adding motion blur to give the appearance of a quick pan. This works best when the duration of the transition is short.

In the Sapphire Transitions category.


From: Starts the transition with this clip.

To: Ends the transition with this clip.


Load Preset: Push-button .
Brings up the Preset Browser to browse all available presets for this effect.

Save Preset: Push-button .
Brings up the Preset Save dialog to save a preset for this effect.

Direction: Popup menu,  Default: Left .
Direction that the clips move during the transition.
Left: Moves right-to-left
Right: Moves left-to-right
Up: Moves upward.
Down: Moves downward.

Amount: Default: 0, Range: 0 to 1.
Determines the transition ratio between the From and To inputs, and would normally be animated from 0 to 1 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the wipe.

Blur Amount: Default: 2, Range: 0 or greater.
Amount of motion blur to use. If the direction is left or right, the blur is horizontal. If the direction is up or down, the blur is vertical.

Overlap: Default: 0, Range: any.
Amount to overlap the two clips. Where the clips overlap, they will be screened together. This is useful for eliminating bad edges.
See general info for: Crop/Transform , Resolution , Clamp Output To Legal , Bypass Effect , and Reset .

See Also:

Sapphire Plug-ins Introduction


Join our email newsletter and keep up to date