Black Friday Sale - Up to 50% OFF all products - Sale limited to one product purchase

Sapphire Plug-ins for After Effects: WipePixelate

S_WipePixelate

Transitions between two input clips by adding blocks of pixels of one clip onto another in a semi-random order. The Wipe Percent parameter should be animated to control the transition speed. Adjust the Edge Width and Chunky parameters for different pixelated patterns.

In the Sapphire Transitions effects submenu.


Inputs:

Foreground: The current layer. Starts the transition with this clip.

Background: Defaults to None. Ends the transition with this clip.

Parameters:

Load Preset: Push-button .
Brings up the Preset Browser to browse all available presets for this effect.

Save Preset: Push-button .
Brings up the Preset Save dialog to save a preset for this effect.

Transition Dir: Popup menu,  Default: Wipe Off to Bg .
Selects the direction of the transition.
Wipe Off to Bg: transitions from the current layer to the Background.
Wipe On from Bg: transitions from the Background to the current layer.

Auto Trans: Popup YES-NO,  Default: No .
If enabled, a transition is performed automatically between the first and last frames of the layer. If this is off, the transition is performed manually by animating the Wipe Percent parameter.

Wipe Percent: Default: 0, Range: 0 to 1.
Auto Trans must be disabled for this parameter to be used. It determines the transition ratio between the From and To inputs, and would normally be animated from 0 to 100 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the wipe.

Edge Width: Default: 1, Range: 0.0138 or greater.
The width of the transition area.

Angle: Default: 0, Range: any.
The angle of the wipe direction in degrees. Use 0 for a wipe from left to right, 90 or -90 for a vertical wipe, 180 for a wipe from right to left.

Pixel Frequency: Default: 20, Range: 0.1 or greater.
Increase for smaller and more pixels, decrease for fewer and larger pixels.

Pixel Rel Width: Default: 1, Range: 0.01 or greater.
The relative horizontal size of the pixels. Increase for wide pixels, decrease for tall ones.

Chunky: Default: 0, Range: 0 or greater.
Increase to cause the pixels to be added with a more clustered ordering.

Seed: Default: 0.23, Range: 0 or greater.
Used to initialize the random number generator. The actual seed value is not significant, but different seeds give different results and the same value should give a repeatable result.

Show Wipe: Check-box, Default: on.
Turns on or off the screen user interface widget for adjusting the Grad Add, Grad Angle, and Wipe Percent parameters. The value of the Grad Add parameter must first be positive for this widget to be visible.This parameter only appears on AE and Premiere, where on-screen widgets are supported.


See Also:

WipeLine
WipeCircle
WipeRectangle
WipeStar
WipeClock
WipeWedge
WipeDoubleWedge
WipeFourWedges
WipeDots
WipeChecker
WipeStripes
WipeRings
WipeBlobs
WipeCells
WipeTiles
WipeDiffuse
WipeBubble
WipeClouds
WipeMoire
WipePlasma
WipePointalize
WipeWeave
WipeFlux
Mosaic
Sapphire Plug-ins Introduction

PRODUCT UPDATES & SPECIAL OFFERS

Join our email newsletter and keep up to date