Tint
Description
Tints the entire image with a selected color using a variety of colorization modes.
Node Group
Tints.
Controls
Presets
To select a preset, choose one from the Presets tab.
Black and White
Enable
Converts the image to Black and White.
Filter
The Filter pop-up selects the type of black and white filter to be applied to your color image. Go to the Black and White section of Common Node Controls to see how the Black and White controls work.
Brightness
Adjusts the brightness of the image. Positive values brighten, negative values darken.
Contrast
Adjusts the contrast of the image. Positive values increase contrast, negative values decrease contrast.
Gamma
Adjusts the gamma of the image. The gamma adjustment leaves the white and black points the same and only modifies the values in-between. Positive values lighten the midtones, negative values darken the midtones.
Tint
Color
Sets the color that the image will be colorized with. Select the desired color using the color picker.
Opacity
Sets the opacity of the color.
Mode
Selects how color is applied to the image.
Normal
Tints the image while retaining highlights.
Tint
The image is tinted by replacing hue and saturation.
Hue
The image is tinted by only replacing hue.
Lighten
Pixels darker than the color are replaced, and pixels lighter than the color do not change.
Darken
Pixels lighter than the color are replaced, and pixels darker than the color do not change.
Grad
Tint can optionally use a gradient that limits where the node is applied. Grad is the transition area that goes from the tinted image to the original image. Its direction, corners and size can be adjusted. Go to the Grad section of Common Node Controls to see how the Grad controls work.