S_SwishPanTransitions between two input clips by sliding one clip off the frame and the other clip on, and adding motion blur to give the appearance of a quick pan. This works best when the duration of the transition is short.In the Sapphire Transitions effects submenu.
Inputs:
|
|
Parameters:
-
Load Preset:
Push-button
.
Brings up the Preset Browser to browse all available presets for this effect.
-
Save Preset:
Push-button
.
Brings up the Preset Save dialog to save a preset for this effect.
-
Wipe Amount:
Default:
0,
Range:
-0.5 to 1.5.
Determines the transition ratio between the From and To inputs, and would normally be animated from 0 to 1 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the wipe.
-
Direction:
Popup menu, ย Default: Left
.
Direction that the clips move during the transition.
-
Left:
Moves right-to-left
- Right: Moves left-to-right
- Up: Moves upward.
- Down: Moves downward.
- Right: Moves left-to-right
-
Left:
Moves right-to-left
-
Blur Amount:
Default:
2,
Range:
0 or greater.
Amount of motion blur to use. If the direction is left or right, the blur is horizontal. If the direction is up or down, the blur is vertical.
-
Overlap:
Default:
0,
Range:
any.
Amount to overlap the two clips. Where the clips overlap, they will be screened together. This is useful for eliminating bad edges.
-
Slow In:
Default:
0.5,
Range:
0 to 1.
If positive, causes the transition to start more gradually.
-
Slow Out:
Default:
0.5,
Range:
0 to 1.
If positive, causes the transition to end more gradually.
