S_DissolveWavesTransitions between two input clips using a waves warping function. The first clip is warped away and faded out while the second clip is unwarped into place and faded in. The Dissolve Amount parameter should be animated to control the transition speed.In the Sapphire Transitions category.
Inputs:
|
|
Parameters:
-
Load Preset:
Push-button
.
Brings up the Preset Browser to browse all available presets for this effect.
-
Save Preset:
Push-button
.
Brings up the Preset Save dialog to save a preset for this effect.
-
Dissolve Amount:
Default:
0,
Range:
0 to 1.
The transition ratio between the From and To inputs. Auto Trans must be disabled for this parameter to be used. This would normally be animated from 0 to 1 to perform a complete transition, and the curve can be adjusted for more detailed control over the timing of the dissolve. The Slow In and Slow Out parameters, if positive, also adjust the transition ratio internally for a smoother start and/or end to the transition.
-
Frequency:
Default:
3,
Range:
0.1 or greater.
The frequency of the waves pattern. Increase for more and smaller elements, or decrease for fewer and larger.
-
Amplitude:
Default:
0.3,
Range:
any.
Scales the amount of warping distortion.
-
Rel Amp2:
Default:
-1,
Range:
any.
The relative amplitude of the second input clip warping distortion. If this is positive instead of negative, the clip will be unwarped from the opposite direction.
-
Angle:
Default:
45,
Range:
any.
The rotation of the overall waves pattern used for the wipe, in counter-clockwise degrees.
-
Displace Angle:
Default:
90,
Range:
any.
The warping direction in degrees relative to the angle of the waves. 0 gives compression-expansion waves, and 90 gives side to side waves.
-
Phase Start:
Default:
0,
Range:
any.
The phase shift of the waves. The wave pattern is translated in the direction of Angle by this amount.
-
Phase Speed:
Default:
0,
Range:
any.
The phase speed of the waves. If this is non-zero the wave pattern automatically travels at this rate.
-
Wrap:
X & Y, Popup menu, Default:
[
Reflect Reflect
].
Determines the method for accessing outside the borders of the source images.
-
No:
gives black beyond the borders.
- Tile: repeats a copy of the image.
- Reflect: repeats a mirrored copy. Edges are often less visible with this method.
- Tile: repeats a copy of the image.
-
No:
gives black beyond the borders.
-
Filter:
Check-box, Default:
on.
If enabled, the image is adaptively filtered when it is resampled. This gives a better quality result when parts of the image are warped smaller.