The S_EdgeRays filter comes from the Emmy award winning Boris FX Sapphire filter set.

Light.

To select a preset, pick one from the Presets window.

The location from which the rays beam outwards.

The length of the rays. A length of 1 gives rays that continue forever, although they may still fade out as they go. To make the rays look longer, you can also increase the Bias Outer Bright parameter. If Rays Length is negative, the rays can beam inwards instead of outwards. Please note that processing times increase for longer rays.

The relative length of the red channel of the rays. Adjust this, along with Length Green and Length Blue, to create color fringing effects.

The relative length of the green channel of the rays.

The relative length of the blue channel of the rays.

Extend rays inward as well as outward. The length of the reversed rays is controlled by Rays Length as well as this parameter.

Scales the brightness of the ray beams.

Blurs the rays.

The relative horizontal and vertical blur widths applied to the rays.

Scales the color of the ray beams.

Allow rays to darken the source as well as brighten it. If enabled, a dark Rays Color will cause rays to darken the source. A bright Rays Color will brighten the source as usual.

Determines the variable amount of brightness along the rays. This is normally near 0 so the rays fade away at their outer ends, 0.5 causes equal brightness along the rays, and 1 causes maximum brightness at the ends.

Selects the resolution factor for the rays. Higher resolutions give sharper rays, lower resolutions give smoother rays and faster processing. This 'Res' factor only affects the rays: the background is still combined with the rays at full resolution.

Full resolution is used.

The rays are calculated at half resolution.

The rays are calculated at quarter resolution.

Selects between output options.

Outputs the rays over the Background.

Outputs only the edge image. This can useful during the adjustment of the edge or shimmer parameters.

Outputs the rays on a black background.

The thickness of the edges which generate the rays.

Scales the brightness of the edges which generate the rays.

Enables subpixel Edge Thickness amounts. Turn this on if you want finer control of small values.

Modulates the ray source image with this amount of noise texture to give the rays a shimmering look.

The frequency of the shimmer texture. Increase for a finer grained shimmer effect or decrease for a larger, softer shimmer. This has no effect unless Shimmer Amp is positive.

Used to initialize the random number generator for the shimmer texture. The actual seed value is not significant, but different seeds produce different results and the same value should give a repeatable result.

Translation of the shimmer texture. This has no effect unless Shimmer Amp is positive.

Atmosphere gives the effect of rays shining through a dusty atmosphere and picking up light or getting shadowed. This parameter adjusts the amount, or amplitude, of the atmospheric effect. A value of 0 creates smooth rays while higher values give a more dusty look.

Controls the spatial frequency of the atmospheric noise. Turn this up higher to get finer details or turn down for broader overall variation.

Controls the amount of fine detail in the atmosphere simulation. Decrease to get smoother atmosphere or increase for a more crunchy, grainy look.

The rays are generated from the alpha channel instead of the RGB channels. In this case, the rays will not use color from the image and will typically be brighter. Values between 0 and 100 interpolate between using the RGB and the alpha.

Set to 1 to composite the image over the rays.

Scales the opacity of the image when combined with the rays. This does not affect the generation of the rays themselves.

Enables/disables the on-screen control for adjusting the Center and Rays Length parameters.